UDUKE FLAP DISC 4-1/2" GRIT #120

4 1/2 in (115 mm) flap disc with a 7/8 in (22 mm) arbor hole, 120 grit (fine grit), for angle grinders. It is made of overlapping abrasive flaps that grind and smooth at the same time and leave a more even finish than a rigid grinding wheel.

With 120 grit it is meant for fine finishing and surface prep before painting. The label shows the maximum speed (13,600 RPM), the 80 m/s peripheral speed and the ISO 9001 mark.

Specifications

• Diameter: 4 1/2 in (115 mm)
• Arbor hole diameter: 7/8 in (22 mm)
• Grit: AZ120
• Type: Flap disc (abrasive flaps)
• Maximum speed: 13,600 RPM
• Maximum peripheral speed: 80 m/s
• Printed certification: ISO 9001
• Contents per item: 1 disc
• Abrasive: Zirconia (AZ)
• Manufacturer code: MPA Z-13743

Includes

• 1 flap disc

Uses

• Fine finishing and surface prep before painting
• Metalwork with an angle grinder

Tips

• Always wear protection: helmet or face shield, hearing protection, goggles, dust mask, gloves and boots, as the label indicates.
• Do not exceed the maximum speed printed on the disc; the grinder must run at the same or lower RPM.
• Inspect the disc before mounting it and discard it if it is dented, warped or has loose flaps.
• Work with the disc tilted a few degrees to the workpiece, without pressing too hard.