UDUKE FLAP DISC 7" GRIT #100

7 in (180 mm) flap disc with a 7/8 in (22 mm) arbor hole, 100 grit (fine grit), for angle grinders. It is made of overlapping abrasive flaps that grind and smooth at the same time and leave a more even finish than a rigid grinding disc.

With 100 grit it is meant for fine finishing and the transition between grinding and polishing. The label shows the maximum speed (8,400 RPM), the 80 m/s peripheral speed and the ISO 9001 mark.

Specifications

• Diameter: 7 in (180 mm)
• Arbor hole diameter: 7/8 in (22 mm)
• Grit: 100
• Type: Flap disc (abrasive flaps)
• Maximum speed: 8,400 RPM
• Maximum peripheral speed: 80 m/s
• Printed certification: ISO 9001
• Contents per item: 1 disc
• Manufacturer code: MPA Z-07090

Includes

• 1 flap disc

Uses

• Fine finishing and transition between grinding and polishing
• Metalwork with an angle grinder

Tips

• Always wear protection: helmet or face shield, hearing protection, goggles, dust mask, gloves and boots, as the label indicates.
• Do not exceed the maximum speed printed on the disc; the grinder must run at the same or lower RPM.
• Inspect the disc before mounting it and discard it if it is damaged, warped or has loose flaps.
• Work with the disc tilted a few degrees to the piece, without pressing too hard.